================================================================================
                                样例使用说明
                             Sample Description
================================================================================
功能描述：
此样例演示了EPWM互补输出死区功能，死区发生器子模块给 AQ 生成的 PWM 波形添加死区。

Function descriptions:
This sample demonstrates the dead-time function of EPWM complementary output.
The dead-time generator submodule adds dead-time to the PWM waveforms generated
by AQ.

================================================================================
测试环境：
测试用板：PY32F420_STK
MDK版本： 5.28
IAR版本： 9.20
GCC版本：GNU Arm Embedded Toolchain 10.3-2021.10

Test environment:
Test board: PY32F420_STK
MDK Version: 5.28
IAR Version: 9.20
GCC Version: GNU Arm Embedded Toolchain 10.3-2021.10
================================================================================
使用步骤：
1. 编译并下载程序；
2. 通过逻辑分析仪捕捉PC6、PC7引脚的电平，判断pwm输出信号是否正确

Example execution steps:
1.Compile and download the program.
2.Use a logic analyzer to capture the signal levels on pins PC6 and PC7, and
verify whether the PWM output signals are correct.

================================================================================
注意事项：
通过USB转TTL模块连接PC与STK板,STK板与USB转TTL模块的连线方式如下；
@PrintfConfigStart
STK板        USB转TTL模块
PA2(TX)  -->  RX
PA3(RX)  -->  TX
GND       -->  GND
UART配置为波特率115200，数据位8，停止位1，校验位None
@PrintfConfigEnd

Notes:
Connect the PC to the STK board through the USB to TTL module, and the connection
method between the STK board and the USB to TTL module is as follows:
@PrintfConfigStart
STK board USB to TTL module
PA2(TX)  -->  RX
PA3(RX)  -->  TX
GND       -->  GND
UART is configured as BaudRate 115200, data bit 8, stop bit 1, and parity None.
@PrintfConfigEnd
================================================================================